788-384 - Relay module with driven contacts; Nominal input voltage: 24 VDC; 2 changeover contacts; Limiting continuous current: 6 A; Red status indicator; Module width: 15 mm; 2,50 mm²; gray

Nominal input voltage U_N

DC 24 V

Input voltage range

-15 … +10 %

Nominal input current at U_N

31 mA

Number of changeover contacts

2

Contact material (relay)

AgNi

Limiting continuous current

6 A

Inrush current (resistive) max.

(AC) 14 A / 4 s

Switching voltage (max.)

AC 250 V

Switching power (resistive) max.

AC 1500 VA; DC see load limit curve

Switching capacity

AC-15: 3 A / AC 250 V; DC-13: 3 A / DC 24 V

Recommended minimum load

5 V / 10 mA

Pull-in time (typ.)

10

Drop-out time (typ.)

4

Electrical life (NO; resistive load; 23 °C)

100 x 10³ switching operations

Mechanical life

10 x 10⁶ switching operations

Switching frequency with/without load (max.)

6 min^-1 / 300 min^-1

Mechanical force-guided operation

Type A

Status indicator

Red LED

Rated voltage

250

Rated surge voltage

4

Pollution degree

3

Dielectric strength (control/load circuit) (AC, 1 min)

4 kVrms

Dielectric strength (open contact) (AC, 1 min)

1.5 kVrms

Dielectric strength (load/load circuit) (AC, 1 min)

3 kVrms

Safety information 1

• Per EN 61810-3, it is only permitted to use 1 make contact/1 break contact for safety circuits (11-14 and 22-21 or 12-11 and 21-24).
• A separator plate (e.g., 209-191) must be used for voltages greater than 250 V between adjacent relay modules and for compliance with the reinforced insulation requirements.

Protection type

IP20