I/O Modules

The separation module visually divides a fieldbus node into sections. Separation module 750-616/030-..

This digital input module receives control signals from NAMUR proximity sensors (per DIN EN 60947-5-..

This module is a single‐channel, intelligent positioning controller for 24 VDC motors up to 5 A with..

This fieldbus coupler connects the WAGO I/O System as a slave to the CANopen fieldbus. Data is trans..

This counter is used for frequency measurement. The counter measures the 24 V signal pulse period at..

This module is an SSI interface for the direct connection to an SSI transmitter. After the module ha..

The ETHERNET TCP/IP Fieldbus Coupler supports a number of network protocols to send process data via..

The 750-363/040-000 EtherNet/IPTM Fieldbus Coupler connects the EtherNet/IPTM fieldbus system to the..

This digital input module features 16 channels in a width of just 12 mm (0.47 inch). It receives bin..

The Modbus TCP / UDP Fieldbus Coupler 750-362 connects the digital, analog and specialty modules of ..

This analog input module processes standard 4–20 mA signals. The input signal is electrically isolat..

This digital output module transmits control signals from the automation device to the connected act..

This analog input module powers the intrinsically safe signal conditioners located in the hazardous ..

Part of the WAGO I/O System 750, the 753-620 DALI Multi-Master DC/DC Converter is just 12 mm (½ inch..

This analog input module directly connects to Pt resistance sensors. Two-wire sensors can be connect..

The PROFIsafe module 75x-661/000-004 can connect to potential-free emergency stop buttons with conta..

This analog output module generates standard ±10 V signals. The output signal is electrically isolat..

This analog input module directly connects to two resistor bridges. The bridge voltage UD and supply..

This analog input module directly connects to NTC sensors. It can be operated as a 4-channel (2-wire..

The WAGO I/O System 750 can also be used in marine applications and onshore/offshore installations (..

The data exchange coupler transfers the input process image data to the output process image of the ..

This digital output module transmits control signals from the automation device to the connected act..

..

The CAN Gateway supports CAN Layer 2, while meeting CAN specifications 2.0A (11-bit identifier) and ..

This digital output module transmits control signals from the automation device to the connected act..