Industrial Control

This fieldbus coupler connects the WAGO I/O System as a slave to the CC-Link fieldbus. The fieldbus ..

..

..

..

This analog input module processes differential signals ranging from 4 to 20 mA. The input signal is..

This digital input module is a 3-wire device featuring four channels in a width of just 12 mm (0.47 ..

PIO3 hardware configuration 2 x ETHERNET port for connecting to field devices and the engineering to..

..

2 x ETHERNET interface for connecting to field devices and IT networks 4 x USB interface for optiona..

This module is an SSI interface for the direct connection to an SSI transmitter. After the module ha..

PIO3 hardware configuration 2 x ETHERNET port for connecting to field devices and the engineering to..

This digital output module controls actuators operating in Zone 0+1 hazardous areas. Intrinsically s..

..

This analog input module powers field-side signal conditioners and transmits electrically isolated a..

..

..

This analog input module directly connects to NTC sensors. Two- or three-wire sensors can be connect..

..

This digital output module transmits control signals from the automation device to the connected act..

This output module modulates a 16-bit information in the frequency. The field side is electrically i..

..

..

Finely adjusting time within these ranges can be made with the trimming potentiometer. St+ is only c..

..

The data exchange module allows the exchange of data between different fieldbus systems. Two modules..